Blount 633GC Manuel de l'opérateur télécharger pdf (Page 12)

TITLE633GC / 633F4 OPERATOR’S MANUAL

COLD ENGINE STARTING PROCEDURE

1. Toggletheignitionswitchtothe"START"positionandpullthe

chokeleverout.

2. Lockthethrottleinthestartpositionbydepressingthetrigger(A)

andtriggerinterlock(B)atthesametime.

3. Depressandholdthrottlelockbutton(C)whilereleasingthetrigger

andtriggerinterlockinsuccession.

4. Open the water valve 1/4 turn.

5. Placethediamondchainsawonthegroundmakingsurethechain

is free of any obstructions.

6. Place right foot on the base of the rear handle.

7. Place left hand on front handle.

8. With right hand, slowly pull starter handle until the starter pawls engage.

9. Pullthestartercord(hard, fast, short pulls)untilenginefiresor"pops"-shouldbe1to7pulls.

10.Pushthechokeleverin.

11. Pullthestartercorduntilenginestarts-shouldbe1to2pulls.

12. When the engine starts, allow the engine to idle. Pull on the throttle trigger several times to help

warm up the engine.

13. Open the water valve completely.

CAUTION

STARTING AND STOPPING A DIAMOND CHAINSAW

Never start a diamond saw without the bar, chain and side cover

properly assembled. Otherwise, the clutch can come loose and

cause personal injuries.

Always move a diamond chainsaw at least 10 feet (3 m) away from

the fueling area before starting.

Place the diamond saw on clear ground. Ensure that secure

footing is established and chain is not contacting any objects.

IMPORTANT

WARNING

WARM ENGINE STARTING PROCEDURE

1. Use the same procedure as starting cold engine, but DO NOT pull choke lever out.Ifchokeisused,the

carburetor will flood with gas.

2. Iftheenginedoesnotstartin3hard,fastpullswiththethrottlelocked,unlockthethrottleandpullthe

starter cord 3 more times.

Note: To hold the trigger fully open it may be necessary to insert right foot into rear handle opening

and twist.

Figure1:a-Trigger,b-trigger

interlock,c-throttlelock

STOPPING THE SAW

• Toturntheengineoff,toggleignitionswitchtothe"STOP"position.Closewatervalve.

OPER ATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Blount 633GC Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Blount 633GC